ICUAS 2020 Paper Abstract

Close

Paper ThA2.6

Ivanovic, Antun (University of Zagreb), Car, Marko (University of Zagreb), Orsag, Matko (University of Zagreb), Bogdan, Stjepan (Univ. of Zagreb)

Exploiting Null Space in Aerial Manipulation through Model-In-The-Loop Motion Planning

Scheduled for presentation during the Regular Session "Path Planning IV" (ThA2), Thursday, September 3, 2020, 11:40−12:00, Kozani

2020 International Conference on Unmanned Aircraft Systems (ICUAS), September 1-4, 2020 (Postponed from June 9-12, 2020), Athens, Greece

This information is tentative and subject to change. Compiled on September 25, 2020

Keywords Path Planning, UAS Applications

Abstract

This paper presents a method for aerial manipulator end-effector trajectory tracking by encompassing dynamics of the Unmanned Aerial Vehicle (UAV) and null space of the manipulator attached to it in the motion planning procedure. The proposed method runs in phases. Trajectory planning starts by not accounting for roll and pitch angles of the underactuated UAV system. Next, we propose simulating the dynamics on such a trajectory and obtaining UAV attitude through the model. The full aerial manipulator state obtained in such a manner is further utilized to account for discrepancies in planned and simulated end-effector states. Finally, the end-effector pose is corrected through the null space of the manipulator to match the desired end-effector pose obtained in trajectory planning. Furthermore, we have applied the TOPP-RA approach on the UAV by invoking the differential flatness principle. Finally, we conducted experimental tests to verify effectiveness of the planning framework.

 

 

All Content © PaperCept, Inc.

This site is protected by copyright and trademark laws under US and International law.
All rights reserved. © 2002-2020 PaperCept, Inc.
Page generated 2020-09-25  15:39:26 PST  Terms of use